Power ToolsHow-To
How to Use a Table Saw Safely: Kickback, Riving Knives and Accurate Cuts
How to use a table saw safely — what actually causes kickback, why the riving knife matters most, and the setup and…
Topic
Power Tools
Drills, saws, routers, grinders and outdoor power tools — how to choose them, use them safely and get accurate results.
Articles
Power ToolsHow-To
How to Use a Miter Saw: Angles, Accurate Cuts and the Sliding Saw Rule
How to use a miter saw accurately — miter vs bevel explained simply, cutting on the correct side of the line, and…
Workshop & SafetyHow-To
How to Sharpen Chisels and Plane Blades: The Burr Method That Actually Works
How to sharpen chisels and plane irons properly — why flattening the back matters as much as the bevel, how to raise…
Power ToolsHow-To
How to Use a Drill Press: Speeds, Clamping and Perfectly Square Holes
How to use a drill press safely and accurately — why you must never hold the workpiece by hand, how to pick…
Workshop & SafetyHow-To
How to Set Up a Small Workshop: Garage, Shed or Spare Corner
How to set up a small workshop in a garage, shed or spare room — the right order to do it in,…
Power ToolsHow-To
How to Choose Cordless Tool Batteries: Voltage, Amp-Hours and Platform Explained
Why 18V and 20V MAX are the same battery, what amp-hours really measure, and why choosing a cordless platform matters more than…
Workshop & SafetyHow-To
How to Glue and Clamp Wood: Get Joints Stronger Than the Timber
How to glue and clamp wood properly — choosing the right adhesive, open time vs cure time, how much clamping pressure, and…
Power ToolsHow-To
How to Use a Leaf Blower: Technique, Noise and CFM vs MPH Explained
How to use a leaf blower properly — the wind-and-tarp technique that halves the time, what CFM and MPH actually mean, and…
Power ToolsHow-To
How to Use a Hedge Trimmer (And Keep the Hedge Healthy)
How to use a hedge trimmer safely — checking for nests first, the taper that stops the base going bare, getting a…
Power ToolsHow-To
How to Drill Into Brick and Masonry (And Pick a Fixing That Holds)
How to drill into brick, block and concrete — checking for cables first, hammer drill vs SDS, when hammer mode is wrong,…